TEL: +86 18320188145 丨 Whatsapp:+86 13909754659 
The Reason And Solutions Of The Filter Not Pumping Water
TIME：2024-06-04 Author：admin Views：
The reason as below:
1. Plating solution filter inlet pipe is blocked.
2. The shaft seal burns out or is in idle state.
3. The impeller sucks in foreign matter and clogs the flow channel.
4. The impeller shaft sleeve is separated, and the impeller is not synchronized with the motor axis.
5. Plating solution filter with vertical pump, the impeller is higher than the liquid level, not easy on the water.
6. electroplating solution filter with magnetic pump, the pump is higher than the liquid level, not easy on the water.
7. Electroplating solution filter equipped with pump motor reversal.
Solutions:
1. Check the inlet pipe as well as the ball valve to see if there is any blockage, find the problem point to give replacement or clear;
2. If the initial use of idling in time to add water in the pump, if the shaft seal burned, replace the shaft seal;
3. Generally in this case, the pump body will have vibration or muffled sound open the main body, clean up debris;
4. Replace the impeller and impeller key, check whether the shaft seal is damaged;
5. Install the bottom valve, check valve, if possible, increase the liquid level in the tank or reduce the height of the filter placement;
6. Install the bottom valve, fill the pipeline pumps with water, increase the self-priming tank, and position the pipeline as far below the liquid level as possible;
7. Ensure that the motor fan blade is clockwise, generally reverse rotation will vibrate, loud sound, adjust to positive rotation can be resolved.
1. Plating solution filter inlet pipe is blocked.
2. The shaft seal burns out or is in idle state.
3. The impeller sucks in foreign matter and clogs the flow channel.
4. The impeller shaft sleeve is separated, and the impeller is not synchronized with the motor axis.
5. Plating solution filter with vertical pump, the impeller is higher than the liquid level, not easy on the water.
6. electroplating solution filter with magnetic pump, the pump is higher than the liquid level, not easy on the water.
7. Electroplating solution filter equipped with pump motor reversal.
Solutions:
1. Check the inlet pipe as well as the ball valve to see if there is any blockage, find the problem point to give replacement or clear;
2. If the initial use of idling in time to add water in the pump, if the shaft seal burned, replace the shaft seal;
3. Generally in this case, the pump body will have vibration or muffled sound open the main body, clean up debris;
4. Replace the impeller and impeller key, check whether the shaft seal is damaged;
5. Install the bottom valve, check valve, if possible, increase the liquid level in the tank or reduce the height of the filter placement;
6. Install the bottom valve, fill the pipeline pumps with water, increase the self-priming tank, and position the pipeline as far below the liquid level as possible;
7. Ensure that the motor fan blade is clockwise, generally reverse rotation will vibrate, loud sound, adjust to positive rotation can be resolved.
